Water Purifier Installation Steps: Detailed Operation Process

After completing the preparation, the water purifier can be installed according to the instructions. The general installation steps are as follows:

Connect the water inlet and outlet: First find the water inlet of the water purifier, and connect the water pipe with the water inlet of the water purifier. In order to avoid water leakage, the installation can be wrapped around the joint to increase the sealing. Then, connect the water outlet of the water purifier to the faucet to ensure that the pipe is tightly connected.

Install the filter element: Most water purifiers require the filter element to be installed before use. According to the product instructions, all levels of the filter element is installed to the designated position, usually in order to insert the coarse filter, activated carbon filter and fine filter in turn into the filter tank, to ensure that the filter element is installed in place to avoid loosening or dislocation.

Water Purifier Factory,    Water Purifier For Home,      Water Purifier Machine,     Water Purifier,      Water Filter Purifier System

Drainage test: After the water purifier is installed, the initial drainage test is carried out to ensure the normal operation of the system. Open the faucet and observe whether there is leakage, while discharging the initial filtered water for a few minutes to remove impurities such as activated carbon powder on the surface of the filter element. The drainage process can help the filter element to fully infiltrate and improve the service life of the water purifier.

Fixed installation position: If the platform type water purifier, it can be directly placed on the platform. For the underwater water purifier, it is necessary to use a supporting bracket to fix the water purifier inside the cabinet to ensure stability. The pipe is fixed and arranged to avoid the pipe knotting or being squeezed to affect the smooth flow of water.

During the installation, pay attention to the tightness of the connection and ensure that each interface does not leak. If water leakage is found, you can reinstall the raw material belt and check the fastness of the joints.